Process information
| Key Data Set Information | |||
| Location | RER | ||
| Reference year | 2024 | ||
| Name |
| ||
| Use advice for data set | Scope: This Environmental Product Declaration is an average EPD for dry adhesives covering the products: UZIN Sigaway Orginal, UZIN Sigaway Tape. The data provided in this EPD refers to the arithmetic mean of the products mentioned. All products covered by this EPD are manufactured at the Sifloor AG plant in Sursee, Switzerland. System boundary: Type of EPD: Cradle to gate with options, modules C1–C4, and module D (A1–A3 + C + D and additional modules). The additional modules are A4 and A5. The underlying LCA addresses all life cycle stages of the average product. The other life cycle stages are not relevant for the product class and no environmental impacts occur in these. The following activities are covered by the relevant modules: A1: Production of raw and auxiliary materials A2: Transport of raw and auxiliary materials to the plant A3: Production in the plant (incl. provision of energy and waste treatment) and the manufacture of the packaging A4: Transport of the packed product to the construction site A5: Installation of the product and disposal of the packaging and waste produced during installation (including the protective paper) C1: Manual removal of the product C2: Transport for disposal C3: As a worst-case scenario thermal treatment of the product in an incineration plant is modelled as end-of-life scenario C4: Not relevant because the product is incinerated (respective impacts declared in C3) D: Credits resulting from thermal utilisation of the product and packaging waste For the environmental impact, the use of green electricity was calculated taking into account the residual electricity mix for the remaining electricity. The proportion of the on-site electricity demand covered by green electricity in the total on-site electricity demand is 100 %. | ||
| Technical purpose of product or process | The different fabric tapes are specially adapted to different substrates and floor coverings and are suitable for full-surface bonding of floor coverings. Substrates that meet the requirements of DIN 18365 are suitable for the use of dry adhesives after levelling. | ||
| Classification |
Class name
:
Hierarchy level
| ||
| General comment on data set | This EPD comprises dry adhesives of the product category: Fabric-Tapes. All products considered here are based on the switchTec dry adhesive technology. This is a technology for floor bonding and fulfils the function of liquid adhesives as an alternative in flooring technology. | ||
| Copyright | Yes | ||
| Owner of data set | |||
| Quantitative reference | |||
| Reference flow(s) |
| ||
| Time representativeness | |||
| Data set valid until | 2029 | ||
| Technological representativeness | |||
| Technology description including background system | The data set is representative for the production, use and disposal of dry adhesives of the category: Fabric Tapes in Europe. Within the manufacturing process, the components of the adhesive component are first added together according to the corresponding formula and mixed under continuous stirring. In two steps, the adhesive component is then first applied to the carrier material on one side and dried in the drying unit. The process is then repeated for the other side. Some substrates are such that the adhesive component penetrates the substrate. In this case, one coating cycle is sufficient and the second adhesive coating step is omitted. To prevent the dry adhesive from sticking to each other when rolled up, a protective paper (liner) is applied to one of the adhesive sides. Thermal utilisation was assumed for the end-of-life cycle. Factory-specific data was used for the production processes. For all other life cycle phases, data sets from Sphera Managed LCA Content (Content Version 2023.2) were used. The LCA model was created with the software LCA for Experts (version 10). Technical data: The various tapes are specially adapted to different substrates and floor coverings to comply with their requirements. Declared unit: This declaration is an average EPD and refers to 1 m2 of the fabric tapes UZIN Sigaway Orginal, UZIN Sigaway Tape and UZIN Pluratex, manufactured by SIFLOOR AG at the Sursee plant. All values stated in this EPD represent the arithmetic mean of the individual values of the products. The products mentioned are manufactured at the same plant, fulfil the same or a comparable function and differ only slightly in their formulation; other life cycle phases are the same, such as production. The declared unit of 1 m2 was chosen as the operating data is recorded either per linear metre [m] or per square metre [m2] and the sales unit is also given in m2. Using the conversion factor of the average mass per square metre, the data given can be related to 1 kg. | ||
Modelling and validation
| Subtype | average dataset | ||||
| LCA methodology report | |||||
| Data sources, treatment and representativeness | |||||
| Documentation of data quality management | |||||
| Data source(s) used for this data set | |||||
| Completeness | |||||
| Validation | |||||
| |||||
| Compliance Declarations | |||||
| Compliance |
Compliance system name
|
Approval of overall compliance
|
Nomenclature compliance
|
Methodological compliance
|
Review compliance
|
Documentation compliance
|
Quality compliance
|
| Compliance |
Compliance system name
|
Approval of overall compliance
|
Nomenclature compliance
|
Methodological compliance
|
Review compliance
|
Documentation compliance
|
Quality compliance
|
Administrative information
| Commissioner and goal | |
| Commissioner of data set | |
| Data generator | |
| Data set generator / modeller | |
| Data entry by | |
| Time stamp (last saved) | 2024-01-29T00:00:00 |
| Data set format(s) | |
| Publication and ownership | |
| UUID | 6984ad83-e349-4403-8e07-0d95195bc1d0 |
| Data set version | 00.02.000 |
| Registration authority | |
| Registration number | EPD-UZI-20230498-IBC1-EN |
| Owner of data set | |
| Copyright | Yes |
| License type | Free of charge for all users and uses |
| Access and use restrictions | None |
Environmental indicators
Indicators of life cycle